User’s Manual 3-16
Features, Utilities and Options
3. Press the CF card eject button to partially extend it out of the computer.
4. Press the extended CF card eject button in order to eject the CF card
partially out of the computer.
5. Grasp the CF card and remove it.
Figure 3-6 Removing a CF card
Memory expansion
You can install additional memory into the computer in order to increase
the amount of system memory that is available. This section describes how
to install and remove optional memory modules.
If the CF card is not inserted all the way into the computer, the eject button
may not cause it to pop out sufficiently to allows it to be grasped. In this
instance, simply push the CF card firmly back into the computer and then
press the eject button again.
CF card
CF card
eject button
If you remove the CF card or turn off the power while the computer is
accessing the CF card you may lose data or damage the CF card.
■ You should place a mat beneath the computer in order to prevent the
computer's lid from becoming scratched or damaged when you are
installing/replacing the memory module. In this instance you should
avoid mats that are made of materials that hold or generate static
electricity.
■ When installing or removing a memory module, you must ensure that
you do not touch any other internal areas of the computer.
■ The Front-side System Bus Speed (FSB) for this computer is 533MHz.
While 667MHz memory modules can be installed, the FSB will depend
on the computer.
To Next Page
Loading...
