User’s Manual 1-12
Getting Started
Data save in Hibernation Mode
When you turn off the power in Hibernation Mode, the computer will take a
moment to save the current data in memory to the hard disk drive. During
this time, the Hard Disk Drive indicator will glow.
After you turn off the computer, and the content of memory has been saved
to the hard disk drive, turn off the power to any peripheral devices.
Restarting the computer
Certain conditions require that you reset the computer, for example if:
■ You change certain computer settings.
■ An error occurs and the computer does not respond to your keyboard
commands.
If you need to restart the computer, there are three ways this can be
achieved:
1. Click start followed by Turn off computer - from the Turn Off
Computer menu select Restart.
2. Press Ctrl + Alt + Del to display the Windows Task Manager, then
select Shut Down followed by Restart.
3. Slide the power button and hold it down for five seconds. Once the
computer has switched itself off, wait between ten and fifteen seconds
before turning the power on again by sliding the power button.
Do not turn the computer or devices back on immediately. Wait a moment
to let all capacitors fully discharge.
To Next Page
Loading...
