User’s Manual 1-11
Getting Started
Benefits of Hibernation Mode
The Hibernation Mode feature provides the following benefits:
■ Saves data to the hard disk drive when the computer automatically
shuts down because of a low battery condition.
■ You can return to your previous working environment immediately when
you turn on the computer.
■ Saves power by shutting down the system when the computer receives
no input or hardware access for the time period set by the System
Hibernate feature.
■ Allows the use of the panel power off feature.
Starting Hibernation Mode
To enter Hibernation Mode, follow the steps below.
1. Click start.
2. Select Turn Off Computer.
3. Open the Turn Off Computer dialog box.
4. Click Hibernate.
Automatic Hibernation Mode
The computer can be configured to enter Hibernation Mode automatically
when you slide the power button or close the lid. In order to define these
settings, you can follow the steps as described below:
1. Click start and open the Control Panel.
2. Open Performance and Maintenance and open Power Options.
3. Select the Hibernate window in Power Options Properties,
select the Enable hibernation check box and click the Apply button.
4. Open TOSHIBA Power Saver.
5. Select the Setup Actions window.
6. Enable the desired Hibernation settings for When I press the power
button and When I close the lid.
7. Click the OK button.
For the computer to shut down into Hibernation Mode, this feature must be
enabled in two places within the TOSHIBA Power Saver, (a) the Hibernate
tab, (b) and the Setup Actions tab.
If you do not configure this feature, the computer will automatically shut
down in Standby Mode. However, if battery power does become depleted,
any data saved in Standby Mode will be lost.
You can also enable Hibernation Mode by pressing Fn + F4 - please refer
to Chapter 5, The Keyboard, for further details.
To Next Page
Loading...
