User’s Manual 3-18
Features, Utilities and Options
4. Loosen the two screws securing the memory module cover in place -
please note that those screws are attached to the cover in order to
prevent it from being lost.
5. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-7 Removing the memory module cover
6. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 45 degree angle before
pressing it down until the latches on either side snap into place.
Figure 3-8 Seating the memory module
Memory module
cover
Screws
Slot B
Slot A
Align the grooves along the edges of the memory module with the locking
tabs on the connector and insert the module into the connector firmly - if
you find it difficult to install the memory module, gently prise the locking
tabs outwards using the tip of your finger.
Please also ensure that you hold the memory module along its left and
right hand edges - the edges with the grooves in.
■ Never allow metal objects, such as screws, staples and paper clips, to
enter the computer or keyboard. Foreign metal objects can create a
short circuit, which can cause computer damage and fire, possibly
resulting in serious injury.
■ Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
To Next Page
Loading...
