User’s Manual 1-15
Getting Started
If the pre-installed files are damaged, you are able to either use the
Recovery Discs you have created or the hard disk drive recovery process
to restore the computer to the state it was in when you originally received it.
To perform this restoration, follow the steps below:
1. Load the Recovery Discs into the optical disc drive and turn off the
computer's power.
2. Hold down the F12 key and turn on the power - when the In Touch
with Tomorrow TOSHIBA logo screen appears, release the F12 key.
3. Use the left and right cursors key to select the optical disc drive icon
from the menu. Please refer to the Boot Priority section in Chapter 7,
HW Setup & BIOS Setup for further information.
4. A menu will be displayed from which you should follow the on-screen
instructions.
When the sound mute feature has been activated by pressing the Fn +
Esc key, be sure to disable this to allow sounds to be heard before starting
the restore process. Please refer to Chapter 5, The Keyboard, for further
details.
When you reinstall the Windows operating system, the hard disk will be
reformatted and all data will be lost.
To Next Page
Loading...
