228
If Something Goes Wrong
Develop good computing habits
5.375 x 8.375 ver 2.3
General tips for installing hardware and software
Here are a few tips to help insure safe and easy installation of
new hardware (printers, pointing devices, external hard
drives, DVD writers, scanners, etc.) and software
(applications like Microsoft Office and Adobe Photoshop, or
utility software such as special toolbars for your web
browser).
ā Create a Restore Point (see āSaving system configuration
with Restore Pointsā on page 223). Before installing
anything, use the System Restore utility to set a Restore
Point (see the section titled Restore Points). If anything
goes wrong, you will then be able to easily restore
Windows to the state it was in prior to the installation,
undoing any changes the installation process introduced.
ā Back up your critical data (see āBacking up your data to
CDs with Windows XPā on page 225).
ā Have your factory Restore/Reconfiguration CD(s) on
hand in case you need any files from them.
ā Do not guess; follow directions carefully! It is often
necessary to run an installation utility firstābefore
connecting a new hardware item to the computer. If the
device is connected first, it may be very difficult to
complete the installation successfully. Always carefully
follow the installation instructions that accompany the
hardware or software.
ā Restart Windows. Always restart Windows after each
installation, even if the installation utility does not
prompt you to do so. This will insure that the installation
is completed, and will clean up anything that the
installation utility left behind.
To Next Page
Loading...
Need help?
General