Toshiba Q9+ - Page 105

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 93
Output Terminal 1 (OUT1) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT1 dis-
crete output terminals O1A and O1B.
The O1A and O1B (OUT1) output terminals change states (open
or close) as a function of a user-selected event. See Table 12 on
page 257 for a listing of the possible assignments for the OUT1
terminals.
In addition, the output terminals must be specified as Normally
Open or Normally Closed.
Direct Access Number —
F130
Parameter Type — Selection List
Factory Default — Damper Com-
mand
Changeable During Run — No
Output Terminal 2 (OUT2) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT2 dis-
crete output terminals O2A and O2B.
The O2A and O2B (OUT2) output terminals change states (open
or close) as a function of a user-selected event. See Table 12 on
page 257 for a listing of the possible assignments for the OUT2
terminals.
In addition, the output terminals must be specified as Normally
Open or Normally Closed.
Direct Access Number —
F131
Parameter Type — Selection List
Factory Default — Acceleration/
Deceleration Completion
Changeable During Run — No
Output Terminal 3 (FL) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the FL output
terminals to one of the user-selectable functions listed in Table 12
on page 257.
In addition, the output terminals must be specified as Normally
Open or Normally Closed.
Direct Access Number —
F132
Parameter Type — Selection List
Factory Default — Failure FL (All
Trips)
Changeable During Run — No
OUT1
OUT2
F130 – F133