Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 95
Output Terminal 7 (OUT5) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT5 dis-
crete output terminal.
In addition, this output terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable OUT5 ter-
minal to one of the user-selectable functions listed in Table 12 on
page 257.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Direct Access Number —
F136
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
Output Terminal 8 (OUT6) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT6 dis-
crete output terminal.
In addition, this output terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable OUT6 ter-
minal to one of the user-selectable functions listed in Table 12 on
page 257.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Direct Access Number —
F137
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
Output Terminal 9 (R2) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the R2 discrete
output terminal.
In addition, this output terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable R2 termi-
nal to one of the user-selectable functions listed in Table 12 on
page 257.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Direct Access Number —
F138
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
F136 – F140
To Next Page
Loading...
