Toshiba Q9+ - Page 160

148 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Process Lower Limit
Program Feedback Feedback Settings
Selecting Process PID at parameter F359 allows for this parame-
ter setting to function as the Lower Limit while operating in the
PID Control mode.
Direct Access Number —
F368
Parameter Type — Numerical
Factory Default — Lower-Limit
Freq. (F013)
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
PID Control Delay Time
Program Feedback Feedback Settings
This parameter is used to delay the start of PID control at start
up. During the wait time set here, the ASD will follow the fre-
quency control input of the process value and the feedback input
will be ignored. When this setting times out, the PID setup
assumes control.
Direct Access Number —
F369
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 2400
Units — Seconds
PID Output Upper Limit
Program Feedback Feedback Settings
Selecting Speed PID at parameter F359 allows for this parame-
ter setting to function as the Upper Limit while operating in the
PID Control mode.
Direct Access Number —
F370
Parameter Type — Numerical
Factory Default — (ASD-Depen-
dent)
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
PID Output Lower Limit
Program Feedback Feedback Settings
Selecting Speed PID at parameter F359 allows for this parame-
ter setting to function as the Lower Limit while operating in the
PID Control mode.
Direct Access Number —
F371
Parameter Type — Numerical
Factory Default — Lower-Limit
Freq. (F013)
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
F368 – F372