178 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Acceleration/Deceleration Switching Frequency 1
Program Special ACC/DEC Special
This parameter sets the frequency at which the acceleration con-
trol is switched from the Accel 1 profile to the Accel 2 profile
during a multiple-acceleration profile configuration.
Direct Access Number —
F505
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
IP Address Setting Method
Direct Access Number —
F576
Program Communications Ethernet Settings Parameter Type — Selection List
This parameter is used to select the method used to set the IP
address for a network device (ASD).
Selecting Manual at this parameter will require that parameters
F577 – F580 and parameters F582 – F584 be used to manually
create the IP address and Subnet Mask Data, respectively, for
the device.
Selecting BOOTP or DHCP results in the IP address being sup-
plied by the server. See F577 for additional information on set-
ting the IP address.
Settings:
0 — Manual
1 — BOOTP
2 — DHCP
Factory Default — Manual
Changeable During Run — Yes
IP Card Data 1
Program Communications Ethernet Settings
Selecting Manual at parameter F576 enables parameters F577 –
F580 to be used to create an IP address for the connected
device.
This parameter is used to configure the IP Data Card 1 section of
the IP address of the device.
Direct Access Number —
F577
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Card Data 2
Program Communications Ethernet Settings
This parameter operates in conjunction with parameter F577.
This parameter is used to configure the IP Data Card 2 section of
the IP address of the device.
See F577 for additional information on this parameter.
Direct Access Number —
F578
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Card Data 1
IP Card Data 2
IP Card Data 3
IP Card Data 4
F505 – F579
To Next Page
Loading...
