Toshiba Q9+ - Page 191

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 179
IP Card Data 3
Program Communications Ethernet Settings
This parameter operates in conjunction with parameter F577.
This parameter is used to configure the IP Data Card 3 section of
the IP address of the device.
See F577 for additional information on this parameter.
Direct Access Number —
F579
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Card Data 4
Program Communications  Ethernet Settings
This parameter operates in conjunction with parameter F577.
This parameter is used to configure the IP Data Card 4 section of
the IP address of the device.
See F577 for additional information on this parameter.
Direct Access Number —
F580
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Subnet Mask Data 1
Program Communications Ethernet Settings
This parameter is used to configure the Subnet Mask Data 1 sec-
tion of the subnet mask for the device.
Selecting Manual at parameter F576 will require that parameters
F577 – F580 and parameters F582 – F584 be used to manually
create the IP address and Subnet Mask Data, respectively, for
the device.
Direct Access Number —
F581
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Subnet Mask Data 2
Program Communications Ethernet Settings
This parameter operates in conjunction with parameter F581.
This parameter is used to configure the Subnet Data Mask 2 sec-
tion of the subnet mask for the device.
See F581 for additional information on this parameter.
Direct Access Number —
F582
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Subnet Mask Data 3
Program Communications Ethernet Settings
This parameter operates in conjunction with parameter F581.
This parameter is used to configure the Subnet Data Mask 3 sec-
tion of the subnet mask for the device.
See F581 for additional information on this parameter.
Direct Access Number —
F583
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Subnet Mask Data
1
Subnet Mask Data
2
Subnet Mask Data
3
Subnet Mask Data
4
F579 – F584