Toshiba Q9+ - Page 192

180 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Subnet Mask Data 4
Program Communications Ethernet Settings
This parameter operates in conjunction with parameter F581.
This parameter is used to configure the Subnet Data Mask 4 sec-
tion of the subnet mask for the device.
See F581 for additional information on this parameter.
Direct Access Number —
F584
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Gate 1 Data 1
Program Communications Ethernet Settings
If using the option board IPE001Z, this parameter is used in con-
junction with parameters F586 – F588 to configure a network
gateway address.
See the IPE001Z Instruction Manual (P/N E6581580) for addi-
tional information on this parameter.
Direct Access Number —
F585
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Gate 1 Data 2
Program Communications Ethernet Settings
See F585 for information on this parameter.
Direct Access Number —
F586
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Gate 1 Data 3
Program Communications Ethernet Settings
See F585 for information on this parameter.
Direct Access Number —
F587
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Gate 1 Data 4
Program Communications Ethernet Settings
See F585 for information on this parameter.
Direct Access Number —
F588
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Gate 1 Data 1
IP Gate 1 Data 2
IP Gate 1 Data 3
IP Gate 1 Data 4
F584 – F589