Toshiba Q9+ - Page 193

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 181
IP Master Data 1
Program Communications Ethernet Settings
If using the option board IPE001Z, this parameter is used in con-
junction with parameters F589 – F592 to configure the network.
Parameters F589 – F592 identify locations that may be used by
the Master ASD in managing transfers to and from the Slave ASD
in a Master-Slave ASD network relationship.
Direct Access Number —
F589
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Master Data 2
Program Communications Ethernet Settings
See F589 for information on this parameter.
Direct Access Number —
F590
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Master Data 3
Program Communications Ethernet Settings
See F589 for information on this parameter.
Direct Access Number —
F591
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
IP Master Data 4
Program Communications Ethernet Settings
See F589 for information on this parameter.
Direct Access Number —
F592
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
I/O Scan Permission
Program Communications Ethernet Settings
This parameter Enables/Disables the ability of the system to read
the terminal settings of the Terminal Board (i.e., F, R, OUT1, FP,
etc.).
Settings:
0 — Prohibit
1 — Permit
Direct Access Number —
F593
Parameter Type — Selection List
Factory Default — Prohibit
Changeable During Run — Yes
IP Master Data 1
IP Master Data 2
IP Master Data 3
IP Master Data 4
F589 – F594