Toshiba Q9+ - Page 247

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 235
My Function Time Data 2
Program My Function My Function Data
This parameter is used to set the response delay of the My Func-
tion Time Data 2 terminal.
The applied discrete input signal must be present at the input ter-
minal of the Q9 Plus ASD for the time setting here for a system
response.
Discrete terminal input activation that does not equal or exceed
this setting will be ignored.
Direct Access Number —
F929
Parameter Type — Numerical
Factory Default — 0.01
Changeable During Run — Yes
Minimum — 0.01
Maximum — 600.00
Units — Seconds
My Function Time Data 3
Program My Function My Function Data
This parameter is used to set the response delay of the My Func-
tion Time Data 3 terminal.
The applied discrete input signal must be present at the input ter-
minal of the Q9 Plus ASD for the time setting here for a system
response.
Discrete terminal input activation that does not equal or exceed
this setting will be ignored.
Direct Access Number —
F930
Parameter Type — Numerical
Factory Default — 0.01
Changeable During Run — Yes
Minimum — 0.01
Maximum — 600.00
Units — Seconds
My Function Time Data 4
Program My Function My Function Data
This parameter is used to set the response delay of the My Func-
tion Time Data 4 terminal.
The applied discrete input signal must be present at the input ter-
minal of the Q9 Plus ASD for the time setting here for a system
response.
Discrete terminal input activation that does not equal or exceed
this setting will be ignored.
Direct Access Number —
F931
Parameter Type — Numerical
Factory Default — 0.01
Changeable During Run — Yes
Minimum — 0.01
Maximum — 600.00
Units — Seconds
My Function Time Data 5
Program My Function My Function Data
This parameter is used to set the response delay of the My Func-
tion Time Data 5 terminal.
The applied discrete input signal must be present at the input ter-
minal of the Q9 Plus ASD for the time setting here for a system
response.
Discrete terminal input activation that does not equal or exceed
this setting will be ignored.
Direct Access Number —
F932
Parameter Type — Numerical
Factory Default — 0.01
Changeable During Run — Yes
Minimum — 0.01
Maximum — 600.00
Units — Seconds
F929 – F933