Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 243
Analog Function Assigned Object 11
Program My Function My Function Analog
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality to which the adjustment of
F959 is applied.
Settings:
0 — Disabled (None)
1 — Acceleration Rate
2 — Upper-Limit Frequency
3 — Acceleration Multiplication Factor
4 — Deceleration Multiplication Factor
5 — Manual Torque Boost
6 — Over-Current Stall (F601)
7 — Thermal Protection
8 — Speed Loop Proportional Gain (F460)
9 — Drooping Gain (F320)
10 — PID Proportional Gain (F362)
See the My Function Instruction Manual (P/N E6581335) for a
complete description of the setup requirements and operational
information of the Analog Function Assigned Object parameter.
Direct Access Number —
F961
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Analog Input Function Target 21
Program My Function My Function Analog
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Analog
Input Function Target 21 terminal.
The function selected at F964 may be adjusted using the input
analog control signal selected here.
Settings:
0 — None (Disabled)
1 — V/I
2 — RR
3 — RX
4 — Optional RX2+, RX2-
5 — Optional V/I
6 — Internal Memory
Direct Access Number —
F962
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
F961 – F964
To Next Page
Loading...
