242 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Input Function Target 3
Program My Function My Function Unit 7
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 3 terminal.
This setting assigns the function of the programmable Input
Function Target 3 terminal to any one of the user-selectable func-
tions listed in Table 11 on pg. 256, Table 12 on pg. 257, or Table
14 on pg. 260.
See F977 for additional information on this parameter.
Direct Access Number —
F957
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Output Function Assigned
Program My Function My Function Unit 7
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the Output Function
Assigned terminal.
This setting assigns the function of the programmable Output
Function Assigned data location to one of the functions listed in
the Input Setting field of Table 12 on pg. 257.
Settings:
0 – 3099
See the My Function Instruction Manual (P/N E6581335) and
F977 for additional information on this parameter.
Direct Access Number —
F958
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Analog Input Function Target 11
Program My Function My Function Analog
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Analog
Input Function Target 11 terminal.
The function selected at F961 may be adjusted using the input
analog control signal selected here.
Settings:
0 — Disabled (None)
1 — V/I
2 — RR
3 — RX
4 — RX2+, RX2-
5 — Optional V/I
6 — Internal Memory
Direct Access Number —
F959
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
F957 – F961
To Next Page
Loading...
