Toshiba Q9+ - Page 61

Program Menu Navigation
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 49
PROTECTION
Abnormal Speed Settings
Abnormal Speed Detection Time
F622
Over-Speed Detection Frequency Upper Band
F623
Over-Speed Detection Frequency Lower Band
F624
Base Frequency Voltage Supply Voltage Correction
F307
DC Braking
DC Injection Braking Start Frequency
F250
DC Injection Braking Current
F251
DC Injection Braking Time
F252
Forward/Reverse DC Braking Priority
F253
Motor Shaft Stationary Control
F254
Dynamic Braking
(not used)
Dynamic Braking Enable
F304
Dynamic Braking Resistance
F308
Continuous Dynamic Braking Capacity
F309
Braking Resistance Overload Time (10x Rated
Torque)
F639
Emergency Off Settings
Emergency Off
F603
Emergency DC Braking Control Time
F604
Low-Current Settings
Low-Current Trip
F610
Low-Current Detection Current
F611
Low-Current Detection Time
F612
Low-Current Detection Current Hysteresis Width
F609
Overload
Motor Overload Protection Configuration
F017
Overload Reduction Start Frequency
F606
ASD Overload
F631
Over-Torque Parameters
Over-Torque Trip
F615
Over-Torque Detection Level During Power Running
F616
Over-Torque Detection Level During Regenerative
Braking
F617
Over-Torque Detection Time
F618
Over-Torque Detection Hysteresis
F619
Under-Torque Detection Under-Torque Detection
F651
Program Mode Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number