Toshiba Q9+ - Page 94

82 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Preset Speed 2
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
0010 and is identified as Preset Speed 2. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F019
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Preset Speed 3
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
0011 and is identified as Preset Speed 3. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F020
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Preset Speed 4
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
0100 and is identified as Preset Speed 4. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F021
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Preset Speed 5
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
0101 and is identified as Preset Speed 5. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F022
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Preset Speed 2
Preset
Speed 3
Preset Speed 4
F019 – F023