Toshiba RAS-10KHP-E3 - 8-2. Installation Diagram of Indoor and Outdoor Units

 − 41 − 
FILE NO. SVM-04004
8-2. Installation Diagram of Indoor and Outdoor Units
Shield
pipe
Air filter
Hook
(Attach to the front panel)
2 Wireless remote
control
65 mm or more
170 mm
or more
8 Pan head wood screw
6 Bioenzyme filter
5 Zeolite filter
4 Remote control holder
13 series 07,10 series
A 600 mm 400 mm
B 100 mm 45 mm
600 mm or more
B mm or more
100 mm or more
A mm or more
600 mm or more
Vinyl tape
Apply after
carrying out a
drainage test.
Extension
drain hose
(Option:
RB–821SW)
Hook
The auxiliary piping can be
connected the left, rear left,
rear right, right, bottom right
or bottom left.
Right
Rear right
Bottom right
Insulate the refrigerant
pipes separately with
insulation, not together.
For the rear left and left
piping
Insert the cushion between
the indoor unit and wall,
and tilt the indoor unit for
better operation.
1 Installation
plate
Wall
Left
Rear left
Bottom left
6 mm thick heat resisting
polyethylene foam
Saddle
Do not allow the drain hose
to get slack.
Make sure to run the drain
hose sloped downward.
Cut the piping hole
sloped slightly
Before installing the
wireless remote control
• With the remote control cover
open, load the batteries supplied
correctly, observing their
polarity.
22
22
2 Wireless remote control
Cover
33
33
3 Batteries
170 mm
or more