4 Replacement Procedures 4.13 Display Mask
4-52 Satellite A100/A105 / TECRA A7 Maintenance Manual
Installing the System Board, USB Board, AC-IN cable
Install the System Board, USB Board, AC-IN cable according to the following procedures
and Figure 4-32.
NOTE:
Be careful of the eject button for the PC card. It can be damaged when installing the
system board. Make sure it is pushed in.
1. Turn the system board upside down and connect the AC-IN cable to CN503.
2. Turn the system board over and connect the RJ11 cable to CN50 on the system board.
3. Seat the system board in the correct position.
4. Secure the system board with one M2x4 black flat-head screw.
5. Seat the MIC in the correct position and connect the MIC cable to CN28 on the
system board.
To Next Page
Loading...
