4 Replacement Procedures 4.14 FL Inverter Board
4-54 Satellite A100/A105 / TECRA A7 Maintenance Manual
Installing the Display Mask
Install the display mask according to the following procedures and Figure 4-33.
1. Seat the display mask in the correct position and secure the following 27 latches, in
that order:
- Six top latches
- Five latches on each of the left and right sides
- Eleven bottom latches
2. Secure the display mask with the following 5 screws, in that order:
- Three M2.5x4.5 white flat-head screws on the top
- Two M2.5x4.5 white flat-head screws on bottom
3. Secure the following 5 seals to cover the screws, in that order:
- Two black seals on the bottom
- Three black seals on the top
To Next Page
Loading...
