4.18 Switch Cover and Button Board 4 Replacement Procedures
Removing the Switch Board (for Commercial Model)
Remove the Switch Board according to the following procedures and Figure 4-40.
1. Remove the Mylar and EMI tape.
2. Disconnect the switch board flat cables from CN4000 on the switch board.
3. Remove two M2.5x4 black flat-head screws.
Figure 4-40 Removing the switch cover
4. Turn the top cover right side up.
5. Remove the following 7 latches on the switch cover, in that order:
- Two right latches
- One latch on the front and bottom sides
- Three left latches
6. Remove the switch board.
Satellite A100/A105 / TECRA A7 Maintenance Manual 4-63
To Next Page
Loading...
