3.2 Quick Start 3 Diagnostic Programs
Satellite A100/A105 / TECRA A7 Maintenance Manual 15
The display of a test program and the set method of PC are shown below.
Display of a Test Program
Set method of PC
7 Test5
Judgment
If all data is less than ranges, it will be OK.
8 Inspection
Judgment
If all data is less than ranges, it will be OK.
9 Setting
Calibration
data
When an inspection result is O.K., calibration at HPC.
If it succeeded, the system will prompt a message of PASS, otherwise the message will
be FAIL.The test information will be written in log file.
Note:
Please do not use this program, when you test PC without 3D sensor.
Left
Upper
To Next Page
Loading...
