3. Tests and Diagnostics
39
3.23 Front Edge Logo
Because this Model have Front Edge Logo, must set the Front Edge Logo if the unit has this logo,
if you select this item, the figure below will be displayed:
Please check the units whether have the Front Edge Logo:
If have the logo, please key 1 to set the Front Edge Logo.
If not have the logo, please key 2 to disable the Front Edge Logo.
Please read the notice to check the function be enable or be disable in BIOS setup menu.
Restart the computer after you change BIOS setting of this function every time.
NOTE: The AC adaptor should be connected to successfully run this test.
To Next Page
Loading...
