Toshiba Satellite A350 - Figure 4.18 Detaching Cables from the Laptop; Installing the Logic Upper Assembly

4 Replacement Procedures Error! Style not defined. Error! Style not defined.
3. Detach one Power board FFC, one Control Panel FFC, two Speaker cables, one
Fingerprinter FFC, one LED Board cable and one TouchPad cable as shown in Figure
4.18.
Figure 4 . 18 Detaching cables from the laptop
4. Lift up the logic upper assembly.
Installing the Logic Upper Assembly
Install the logic upper assembly according to the following procedures.
1. Seat the logic upper assembly to the front of the laptop, and adjust to the correct position.
2. Attach the seven cables and secure the five screws as indicated in Figure 4.17.
3. Turn the laptop upside down and secure it with 19 screws as indicated in Figure 4.16:
− Sixteen M2.5x10 screws
− Three M2.5x3 screws
Satellite A350 Maintenance Manual 4-28