Toshiba Satellite M100 - Page 140

4 Replacement Procedures
4-14
[CONFIDENTIAL]
Satellite M100 Series Maintenance Manual
3. Pull up and lift the HDD door to remove it.
Figure 4-10 Removing the HDD door
4. Pull out the black Mylar tab to remove the HDD unit.
Figure 4-11 Removing the HDD
5. Remove the four M3x3 silver screws that secure the HDD case and bracket to the HDD.
6. Remove the HDD from the HDD case.
Installing the HDD
To install the HDD, follow these steps and refer to the figures in the preceding section.
1. Seat the HDD in the HDD case and bracket, and secure it with four M3
×
3 silver screws.
2. Insert the HDD unit into the HDD slot.
3. Secure the HDD door with a black M2.5x4 screw.