Toshiba Satellite M100 - The Diagnostic Test

3.1The Diagnostic Test 3. Tests and Diagnostics
Satellite M100/TECRA A6 Series Maintenance Manual 3-3
3.1 The Diagnostic Test
This chapter explains how to use the Test & Diagnostic program to test the functions of the
(Base on Cleveland10 T&D version 1.0) hardware modules. The Test & Diagnostic Program is
stored on the T&D diskettes. The program consists of a series of tests that run automatically
when the Diagnostics Program items are selected and executed.
NOTES: To start the diagnostics, follow these steps
1. Check all cables for loose connections.
2. Exit this program when you are at Main Menu.
The TEST & DIAGNOSTIC PROGRAM contains the following functional tests:
 CONFIG CHECK TEST
 DMI CHECK TEST
 SPEAKER AUDIO TEST
 FAN ON/OFF TEST
 MAIN BATTERY CHARGE TEST
 FDD TEST
 ODD TEST
 KEYBOARD TEST
 MOUSE(PAD) TEST
 LCD PIXELS MODE TEST
 MAGNETIC SWITCH TEST
 HDD R/W TEST
 LAN TEST
 RTC TEST
 IEEE1394 CODE TEST
 Speaker EQ Check&Rewrite
 Button Test
 Fingerprint DOS Test
 3D G-Sensor Test
 Clear FP(Fingerprint) Registered
You will need the following equipment to perform some of the Diagnostic test programs.
 The diagnostics diskette (2 pcs)
 A formatted working diskette for the floppy disk drive test (Floppy Disk Drive Test)
 A data CD disc (ODD Test)
The following sections explain how to execute the Test & Diagnostic Program and detail the
tests within the program.