Toshiba Satellite M100 - Removing the Screws; Figure; Removing the Connectors; Removing the FL Inverter Board

4 Replacement Procedures
Satellite M100 Series Maintenance Manual
[CONFIDENTIAL]
4-69
4.25 FL Inverter Board
Removing the FL Inverter Board
To remove the FL inverter board, first remove the battery pack, display assembly, and display
mask; then follow the steps below.
1. Remove one M2.5x4 black screw securing the FL inverter board to the LCD display
assembly.
Figure 4-79 Removing the screws
2. Disconnect the two connectors on either side of the board.
Figure 4-80 Removing the connectors