4 Replacement Procedures
4-42
[CONFIDENTIAL]
Satellite M100 Series Maintenance Manual
4.15 Display Assembly
Removing the Display Assembly
To remove the display assembly, first remove the battery and any optional devices. Also remove
the keyboard, and the wireless LAN unit as described in the previous sections. Then follow the
steps below:
1. Remove the keyboard and the wireless LAN unit. Separate the wireless LAN antenna
connectors (black and white) from the top cover and place them on a side out of the way.
Also remove the Bluetooth antenna connector (brown) from the module.
2. Disconnect the black LCD power (LVDS) cable, Bluetooth cable, and wireless LAN cable
from the system board.
Figure 4-45 Disconnecting cables
3. Remove two M2.5x6 black screws securing the LCD assembly from the rear side.
Figure 4-46 Disconnecting the rear screws
To Next Page
Loading...
