CIX40 Installation
CIX40 Default Initialized Data
1-40 Strata CIX40 Installation & Maintenance 5/06
Table 1-24 Program 100 Default Data
Virtual
Slot
Equip.
Nos.
Circuits
PCB
Code
1
1.The GMAU2, GIPH1, GVPH1 and GSTU1 PCB Slot Codes and the Station/CO Line
numbers are set during initialization even if the cards are not installed in the cabinet. The
GCDU2 must be installed in the cabinet before initialization for auto recognition of slot
code, station numbers and CO line numbers.
Station / Line
Numbers
Connection
0101 8 - Digital Telephones (no spkr OCA) 017 200~207
GMAU2
(motherboard)
0102 3 - CO lines, with CLID 028 CO1~CO3
0103 Not used
0104 Standard Telephone 01~02 026
01~208
02~217
01-GMAU2
02-GSTU1
0105 4 - Voice Mail ports
026
220~223 GVPH1
0106 8 - Channel IP Interface 036 Not assigned
2
2.The ports must be assigned, after the card is installed. The GIPH is the only CIX40 card
that requires licensing. Use eManager to install Strata Net, End point and SoftIPT licenses
and, assign PDNs and Strata Net channels.
GIPH1
0107 8 - Digital Telephones 017 209~216
GCDU2
3
3.When the GCDU2 is installed after the CIX40 is initialized use eManager to assign the
slot code, station numbers and CO line numbers.
0108 3 - CO Lines with CLID 028 CO4~CO6
0205 Virtual BIOU 020
Relay Contact
Page, MOH
GCTU2
*Slot codes are set during system initialization and cannot be changed.
Table 1-25 Program 200 Default Data
GMAU2
FB0 DN 200 201 202 203 204 205 206 207 208
FB1 EQUIP 010101 010102 010103 010104 010105 010106 010107 010108 010401
FB2 DKT DKT DKT DKT DKT DKT DKT DKT SLT
FB3 Ext. Ext. Ext. Ext. Ext. Ext. Ext. Ext. Ext.
FB19 VM ID 200 201 202 203 204 205 206 207 208
FB22
VM MW
Center
Port
250 250 250 250 250 250 250 250 250
FB35
Station
Speed
Dial Bins
10 10 10 10 10 10 10 10 10
To Next Page
Loading...
