3.31 SETUP 3 Tests and Diagnostics
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 3-99
12. PCI Bus
This item displays the interrupt level for the Card Bus. It is for information only and
cannot be changed.
PCI BUS = IRQ10, IRQ11
13. Display
This group of options configures the computer’s display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected Selects an external monitor if one is connected.
Otherwise it selects the internal LCD. (Default)
LCD+AnalogRGB Selects both the internal LCD and the external monitor
for simultaneous display.
NOTE: Pressing Fn+F5 changes the display setting in the order of internal LCD to
simultaneous to external monitor.
14. Peripheral
Use this option to select the parallel port mode and hard disk mode.
(a) Internal Pointing Device
This option enables and disables the Dual Point.
Enabled Enables the Dual Point. (Default)
Disabled Disables the Dual Point.
To Next Page
Loading...
