Toshiba Tecra M9 - Slim Select Bay Module

4.6 Slim select bay module 4 Replacement Procedures
4.6 Slim select bay module
Removing the slim select bay module
The following describes the procedure for removing the slim select bay module. (See Figure
4-9 and 4-10.)
The explanation and figure shown below are the optical disk drive removing/installing.
CAUTION: Do not put fingers in the slot for the slim select bay module. It may cause
injury.
1. Remove the following screw securing the latch and drive the removed screw into the
screw hole. (The slim select bay is unlocked.)
• M2.5×4B FLAT HEAD screw ×1
2. While sliding the latch toward the arrow direction in the Figure 4-9 and pull out the
slim select bay module while holding the hook to disconnect it from the connector of
the system board.
Slim select bay module
Latch
M2.5×4B FLAT HEAD
Screw hole
Hook
Figure 4-9 Removing the slim select bay module
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-19