Toshiba Tecra M9 - HDD Cable;DC-IN Jack

4.21 HDD cable/DC-IN jack 4 Replacement Procedures
4.21 HDD cable/DC-IN jack
Removing the HDD cable/DC-IN jack
The following describes the procedure for removing the HDD cable/DC-IN jack. (See Figure
4-32.)
1. Peel off the insulator and disconnect the HDD cable from the connector CN1900 on
the system board.
2. Disconnect the DC-IN jack cable from the connector CN8800 on the system board.
Insulator
DC-IN jack cable
HDD cable
CN1900
CN8800
Figure 4-32 Removing the HDD cable/DC-IN jack
Installing the HDD cable/DC-IN jack
The following describes the procedure for installing the HDD cable/DC-IN jack. (See Figure
4-32.)
1. Connect the DC-IN jack cable to the connector CN8800 on the system board.
2. Connect the following HDD cable to the connector CN1900 on the system board and
stick the insulator in place.
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-63