4 Replacement Procedures 4.11 Fan holder
4.11 Fan holder
NOTE: When repairing the PC, be sure to clean the fan holder and cooling fin with a
vacuum cleaner and cotton sticks, and remove dusts with tweezers.
Removing the fan holder
The following describes the procedure for removing the fan holder. (See Figure 4-18.)
1. Peel off the insulator that prevents a waterdrop from entering the computer and
remove the fan holder from the slot.
Insulator
Fan holder
Figure 4-18 Removing the fan holder
Installing the fan holder
The following describes the procedure for installing the fan holder. (See Figure 4-18.)
1. Install the fan holder into the slot and stick a new insulator that prevents a waterdrop
from entering the computer in place.
NOTE: Do not reuse the removed insulator.
4-30 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
To Next Page
Loading...
