Toshiba Tecra M9 - Cover Assembly and Base Assembly; Removing the Cover Assembly and Base Assembly; Model)

4 Replacement Procedures 4.14 Cover assembly and Base assembly
4.14 Cover assembly and Base assembly
4.14.1 Removing the cover assembly and base assembly (Not Smart card
Model)
The following describes the procedure for removing the cover assembly and base assembly.
(See Figure 4-24 and 4-25.)
1. Close the display and turn over the computer.
2. Remove the following screws.
• M2.5×8B FLAT HEAD screw ×3 (“8” in the figure below)
• M2.5×16B FLAT HEAD screw ×6 (“16” in the figure below)
8
8
8
16
16
16
16
16
16
Figure 4-24 Removing the cover assembly and base assembly (1)
4-44 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)