4 Replacement Procedures 4.27 Hinge
4.27 Hinge
Removing the Hinge
The following describes the procedure for removing the hinge. (Figure 4-47 and 4-48.)
1. Push the LCD mask down.
CAUTION: Do not push the top of the LCD mask. It may break the LCD mask.
2. Remove the following screws.
• M2.5×4B FLAT HEAD screw ×4
3. Stand the hinges up with the LCD mask and remove the LCD mask.
M2.5×4B FLAT HEAD
M2.5×4B FLAT HEAD
LCD mask
Figure 4-48 Removing the hinge (1)
4-84 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
To Next Page
Loading...
