4 Replacement Procedures 4.20 Base latch
4.20 Base latch
Removing the base latch
The following describes the procedure for removing the base latch. (See Figure 4-31.)
1. Remove the base caps on the bottom while releasing latches.
2. Remove the base latches. Be careful not lose the springs.
Base latch
Base latch
Base latch
Base cap
Base cap
Base cap
Spring
Spring
Spring
Figure 4-31 Removing the base latch
Installing the base latch
The following describes the procedure for installing the base latch (See Figure 4-31).
1. Install the springs to the base latches.
2. Install the base latches to the slot of the base assembly.
3. Install the base caps while engaging the latches.
4-62 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
To Next Page
Loading...
