4 Replacement Procedures 4.22 MDC
4.22 MDC
Removing the MDC
The following describes the procedure for removing the MDC. (See Figure 4-33.)
1. Remove the following screws securing the MDC.
• M2×4B BIND screw ×2
2. Remove the MDC from the connector CN3010 on the system board.
3. Disconnect the MDC cable from the connector on the MDC.
MDC
MDC cable
CN3010
M2x4B BIND
Figure 4-33 Removing the MDC
Installing the MDC
The following describes the procedure for installing the MDC. (See Figure 4-33.)
1. Connect the MDC cable to the connector on the MDC.
2. Install the MDC to the connector CN3010 on the system board and secure it with the
following screws.
• M2×4B BIND screw ×2
4-64 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
To Next Page
Loading...
