4.27 Hinge 4 Replacement Procedures
4. Turn over the cover assembly and remove the following screws and metal plate.
• M2.5×6C Tapping screw ×1
• M2×4B S-THIN HEAD screw ×1
5. Slide the left hinge inside and remove it through the hole.
6. Remove the following screw and right hinge.
• M2.5×6C Tapping screw ×1
7. Slide the right hinge inside and remove it through the hole.
M2.5×6C Tapping
Hinge (left)
M2.5×6C Tapping
M2×4B S-THIN HEAD
Hinge (right)
Metal plate
Figure 4-49 Removing the hinge (2)
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-85
To Next Page
Loading...
