4 Replacement Procedures 4.27 Hinge
4-86 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
Installing the Hinge
The following describes the procedure for installing the hinge. (Figure 4-47 and 4-48.)
1. Pass the right hinge through the hole and secure it with the following screw.
• M2.5×6C Tapping screw ×1
2. Pass the left hinge through the hole.
3. Secure the left hinge and metal plate with the following screws.
• M2.5×6C Tapping screw ×1
• M2×4B S-THIN HEAD screw ×1
4. Set the LCD mask to the hinges and secure it with the following screws.
• M2.5×4B FLAT HEAD screw ×4
To Next Page
Loading...
