4 Replacement Procedures 4.6 Slim select bay module
3. Remove the following screws, connector cover and connector from the optical drive
assembly.
• M2×6C BIND screw ×2
4. Remove the following screw and connector base from the optical drive assembly.
• M2×2.8C S-THIN HEAD screw ×1
5. Remove the following screws and ODD side assembly from the optical drive
assembly
• M2×6C BIND screw ×1
• M2×22C BIND screw ×1
M2×6C BIND
M2×6C BIND
M2×2.8C S-THIN HEAD
M2×6C BIND
M2×22C BIND
ODD side assembly
Connector cover
Connecto
Connector base
Figure 4-10 Detaching the optical disk drive assembly
4-20 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
To Next Page
Loading...
