4.16 Fingerprint sensor board 4 Replacement Procedures
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-53
Installing the Fingerprint sensor board
The following describes the procedure for installing the fingerprint sensor board. (See Figure
4-26 and 4-27.)
1. Connect the fingerprint sensor cable to the connector on the fingerprint sensor board.
2. Stick a new double-sided tape in place and install the fingerprint sensor board.
NOTE: Do not reuse the removed double-sided tape.
3. Install the fingerprint sensor board hold plate while sliding it to the guides.
4. Arrange the fingerprint sensor cable and stick the glass tape in place.
To Next Page
Loading...
