4.23 North bridge heat sink/CPU heat sink/Fan/CPU 4 Replacement Procedures
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-67
Figure 4-36 Removing the CPU heat sink (with a fan)
M2x4B BIND
Metal plate
CPU heat sink
CN8771
CPU hold plate
Fan cable
(With a fan)
cetate tape
10. Remove the fan holder.
11. Remove the following screws and separate the CPU heat sink and fan. (Fan cable is
secured to the fan by the insulator.)
• M2.5×3B FLAT HEAD screw ×2
Figure 4-37 Removing the fan
M2.5×3B FLAT HEAD
CPU heat sink
Fan holder
Fan
To Next Page
Loading...
