STE 80747
– 16 –
DUST-PROOF & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
2.2.2 Transporting the Robot
The dust-proof and drip-proof specification robot has dust-proof and drip-proof parts
such as bellows, etc. added to the standard robots. The instructions during transport of
the robot are listed below. The instructions other than those listed below are the same
as those for the standard robots. Refer to the TH650A Installation and Transportation
Manual provided separately.
Fig. 2.2 Robot handling prohibited areas
After the installation, remove the clamp and eyebolt used for transport.
DO NOT hold
the bellows.
DO NOT hold
the bellows.
DO NOT hold the tool flange
and ball screw spline shaft.
DO NOT hold the
connectors.
DO NOT hold
the arm 2 cover.
Handling areas
(shaded areas)
To Next Page
Loading...
