STE 80747
– 43A –
DUST-PROOF & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
2) Though the cover is embedded to the arm 2, liquid gasket is applied to the
circumference of the packing under the cover to protect the robot against dust and
drip. When detaching the cover, strip off the liquid gasket over the whole surface
between the arm 2 and the packing using a cutter or the like. Then strip off the
liquid gasket gradually with a minus screwdriver or the like before detaching the
cover. DO NOT strip off the liquid gasket applied between the cover and the
packing. Detach the cover together with the packing.
Fig. 5.8 Arm 2 cover (2)
When mounting the cover, apply liquid gasket to the area shown in Fig. 5.8 above.
Also, apply Loctite adhesives to all attaching bolts.
Arm 2 body
Packing
DO NOT strip off
liquid gasket.
Liquid gasket
(Strip off using a
cutter, etc.)
Apply liquid gasket to the
whole surface of the whole
circumference surface (on
which the liquid gasket has
been stripped off before
detaching the cover).
Cross section
of packing
Cover
To Next Page
Loading...
