STE 80747
– 18 –
DUST-PROOF & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
3. Installation
3.1 Installation Environment
Table 3.1 shows the environmental specifications for the robot and controller.
Table 3.1 Environmental specifications
Item Specifications
In operation : 0 to 40°C Temperature
In storage : –10 to 50°C
Humidity 20 to 90 % (Non-condensing)
Altitude 1000 m or less
Vibration In operation : 0.98 m/s
2
or less
Dust No inductive dust should exist.
Gas No corrosive or combustible gas should exist.
Sunlight The robot and controller should not be exposed to direct sunlight.
Power noise A heavy noise source should not exist nearby.
Magnetic field A heavy magnetic field source should not exist nearby.
Dust-proof and
drip-proof
Any place where the equipment sinks in liquid shall not exist.
Small chips involved in turning or cutting operation shall not be
contained.
Mist of cutting fluid or coolant oil shall not be contained.
!
DANGER
• Do not place the robot or controller near combustible. If it is not be done
completely, an ignition may occur due to a fault causing a fire.
To Next Page
Loading...
