STE 80747
– 40 –
DUST-PROOF & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
Cover used for
connector panel as
well
Gasket
Apply liquid gasket to the whole surface of the
gasket.
Folded sections
Cross-recessed
truss head
screw (M4x6)
5.4.1 Base Cover
Two type of base cover are available: One is used for connector panel as well; other for
battery box as well.
1) The base cover used for the connector panel as well is secured to the base with
nine (9) cross-recessed truss head screws (M4x6) and two (2) hexagonal socket
head bolts (M4x10) in such a way to surround the gasket. The gasket attachment
surface is coated with liquid gasket. Remove the cover while stripping off the
liquid gasket using a minus screwdriver or the like. DO NOT pull the cover by
force because it is connected to the connector and other components internally.
Fig. 5.4 Cover used for connector panel as well
When mounting the cover, apply liquid gasket to the area shown in Fig. 5.4 above.
Especially, apply excessive amount of liquid gasket to the folded sections of the
cover.
After assembly, apply liquid gasket to the whole area of the cover attachment
surface to fill a gap between the gasket, cover, and base. Also, apply Loctite
adhesives to all attaching bolts.
Hexagonal socket head bolt
(M4x10)
To Next Page
Loading...
