TOSHIBA
5 - 10
CAUTION
DANGER
5.10.2 Dynamic Braking (cont'd)
4) DB resistors should be installed as near to the inverter as possible with
temperature constraints in mind.
5) Exercise caution when working around
the DB resistors; they can become
extremely hot when used in conjunction with long duty cycles and high
inertia loads.
6) PA-PB dynamic braking
resistor (DBR) terminals are at
high DC bus voltage potential. Do not touch PA - PB terminals when
the charge or power LED lamp is on.
Note:
Consult factory for DBR sizing.
To Next Page
Loading...
