TOSHIBA
or Accesses the V/f parameter.
The inverter must always be placed in the function
mode before accessing any function.
Accesses the voltage boost parameter.
8.0 Operating Procedures (Cont'd)
8 - 2
A
NEXT
NEXT/READ
[value]"Pt" register
New [value]
Entered
NEXT/READ
[value]
NEXT/READ
[value]"vb" register
"vL" register
NEXT
NEXT
WRT
WRT
WRT
New [value]
Entered
New [value]
Entered
Display of new
value entered
Display of
Register Contents
READ
READ
A
READ
or Accesses the maximum voltage frequency parameterNEXT
V/F
1
READ
READ
Key Action Display
MON
Displays the current "vb" setting. :[value]
READ
and Enter new value followed by the WRT key. The unit
will then display the new current "vL" setting. :[new value]
NEW
VALUE
WRT
Displays the current "vL" setting. :[value]
NEXT
READ
Displays the current "Pt" setting. :[value]
READ
Accessing Function #1
Note:
Current value of each parameter does not have to be read. Press NEXT key for next parameter.
Function #1 Flowchart (Once function is accessed the flowchart is as follows)
To Next Page
Loading...
