Toshiba V Series - Page 81

6F8C0903
61
4.2 S Controller Interface Buffer Memory Configuration
4
(13)Input/output data setting information (0304H to 0583H: 640 words)
Indicates to which part of the input/output data area is allocated the input/output data
of each slave device (node address: NA). The input/output data setting information
has 10 words per slave device.
Figure 4-12 shows the top addresses in the areas where information on each node is
stored. Table 4-10 shows the meanings of each slave device.
Data is entered in these areas when the DN311 is set to run mode (transmission
enabled) by an operation mode control request after the slave device parameters are
set. "0" is set in areas where no slave device exists.
Figure 4-12 Input/Output Data Setting Information Addresses
0304H NA=0 03E0H NA=22 04BCH NA=44
030EH NA=1 03EAH NA=23 04C6H NA=45
0318H NA=2 03F4H NA=24 04D0H NA=46
0322H NA=3 03FEH NA=25 04DAH NA=47
032CH NA=4 0408H NA=26 04E4H NA=48
0336H NA=5 0412H NA=27 04EEH NA=49
0340H NA=6 041CH NA=28 04F8H NA=50
034AH NA=7 0426H NA=29 0502H NA=51
0354H NA=8 0430H NA=30 050CH NA=52
035EH NA=9 043AH NA=31 0516H NA=53
0368H NA=10 0444H NA=32 0520H NA=54
0372H NA=11 044EH NA=33 052AH NA=55
037CH NA=12 0458H NA=34 0534H NA=56
0386H NA=13 0462H NA=35 053EH NA=57
0390H NA=14 046CH NA=36 0548H NA=58
039AH NA=15 0476H NA=37 0552H NA=59
03A4H NA=16 0480H NA=38 055CH NA=60
03AEH NA=17 048AH NA=39 0566H NA=61
03B8H NA=18 0494H NA=40 0570H NA=62
03C2H NA=19 049EH NA=41 057AH NA=63
03CCH NA=20 04A8H NA=42
03D6H NA=21 04B2H NA=43